Trunk / Liftgate Striker: Service and Repair

Striker Pin

Removing





- Remove rear cross panel trim..

- Remove the nuts - 1 - and - 3 - and remove the striker pin - 2 -.

Installation

• Tightening specifications, refer to => [ Rear Lid Lock and Striker Pin Assembly Overview ] Description and Operation.

Installation is reverse of removal, but note the following:

- Install the striker pin.

• The round side - arrow - on the striker pin faces upward.

- Adjust the striker pin, refer to => [ Rear Lid, Adjusting ] Rear Lid, Adjusting.