Coolant Pump

Coolant Pump

Removing

- Remove small coolant pipe. Refer to => [ Small Coolant Pipe ] Small Coolant Pipe.

- Remove the toothed belt from the coolant pump. Refer to => [ Coolant Pump Toothed Belt ] Coolant Pump Toothed Belt.

- Disconnect the connector - 1 - from the throttle valve control module (J338).






- Remove bolts - arrows - and remove throttle valve control module.

- Disconnect the connector - 1 - from the Engine Coolant Temperature (ECT) sensor (G62).






• Ignore - 2 and arrows -.

- Remove the bolts - 1 to 5 -.






- Remove the coolant pump from the centering pin and remove the engine oil cooler.

• Ignore - arrow -.

Installing

• Tightening specification, refer to => [ Coolant Pump and Thermostat Overview ] Coolant Pump and Thermostat Overview.

Install in reverse order of removal. Note the following:

• Replace the seals and the O-rings.

- Coat the O-rings - 4 - with coolant; coolant, refer to the Parts Catalog.






- Make sure both centering pins are installed in the cylinder block.

- Install the connection piece - 2 - into the engine oil cooler - 1 -.

- Push the coolant pump - 3 - onto the connection piece and onto the centering pins in the cylinder block.

- Tighten bolts - 1 to 5 -.






• If a new coolant pump was installed, then the protective cap - arrow - must be removed.

- Install the toothed belt on the coolant pump. Refer to => [ Coolant Pump Toothed Belt ] Coolant Pump Toothed Belt.

- Install the oil separator. Refer to => [ Oil Separator ] Service and Repair.

- Install the throttle valve control module.

- Install the small coolant pipe. Refer to => [ Small Coolant Pipe ] Small Coolant Pipe.

- Install after-run coolant pump (V51) => [ After-Run Coolant Pump (V51) ] After-Run Coolant Pump (V51).

- Connect the coolant hose to the coupling. Refer to => [ Connect the Coolant Hose to the Coupling ] Radiator and Coolant Fan Overview.