Rear Final Drive 0BR/0BS/0BY, Gear Oil, Checking

Rear Final Drive 0BR/0BS/0BY, Gear Oil, Checking

Special tools, testers and auxiliary items required

• Torque Wrench 5-50 Nm (V.A.G 1331)

• Charging Device F/Haldex 2 Coup. (VAS 6291)

• Drip Tray for VAS 6100 (VAS 6208)

Test Requirement

• The vehicle must be horizontal.

• For the transmission fluid specification for rear final drive, refer to the Electronic Parts Catalog (ETKA).

Oil Level, Checking

- Place (VAS 6208) under final drive.

- Remove the bolt - 1 -.






The oil level is correct when the rear final drive is filled up to the lower edge of the filler hole.

- Screw in the bolt - 1 - and tighten.

Tightening Specification: 15 Nm

Oil, Filling:

- Add enough oil using the (VAS 6291) until it runs out between the filler tool adapter and the transmission housing.

- Remove the filler tool and adapter; a little oil left over will run out.

The oil level is correct when the rear final drive is filled up to the lower edge of the filler hole.

- Screw in the bolt - 1 - and tighten.

Tightening Specification: 15 Nm