02EA (S-Tronic) Transmission, (3.2L MPI)

Transmission Mount and Transmission Support

Special tools, testers and auxiliary items required

• Engine Support Bridge (10 - 222 A)

• Bracket for Engine (10 - 222 A /1)

• Bracket with Spindle and Hook (10 - 222 A /10)

• Spindle (10 - 222 A /11)

• Shackle (1 Set=2 Pieces) (10 - 222 A /12)

• Engine Support Basic Set (T40091)

• Engine Support Supplement Set (T40093)

• Bracket (T10338)

Removing






- Remove the air filter housing.

- Remove the bolts - arrows - and remove the air filter housing bracket.

- Install the (T10338) on the open threaded hole at left rear of the engine.






- Position (10 - 222 A) with the following tool components on the upper edges of engine compartment:






• (10 - 222 A /1) , quantity: 2

• (10 - 222 A /10) (spindle faces toward rear)

• (10 - 222 A /11) (spindle faces toward front)

• (10 - 222 A /12)

• Connectors (T40091/3) , quantity. 2

- Attach the (10 - 222 A /11) and (10 - 222 A /12) to the right engine lifting eye.

- Engage (10 - 222 A /10) on (T10338).

- Lightly tension the engine/transmission assembly with spindles.

- Install the left adapter (T40093/3-2) and (T40093/3-3) and right adapter (T40093/3).






- Remove the Ground (GND) wire from left longitudinal member.

- Remove the left and right connecting bolt for front section of the long member.

- Install the adapters on longitudinal members with the bolts that were removed earlier - arrow -.

• The left side of the vehicle is shown in the illustration.

- Insert the square tubes (T40091/1) into the connector (T40091/3) and supports (T40093/3) , as illustrated.






- Slide the connector (T40093/4) onto the square tube.






- Slide the support (T40091/2) with the (T40093/5) into both (T40093/4).

Risk of an accident due to loose support bridge parts.

• Secure the engine support supplement set (T40091/2) with the bolts and splints from the (T40093/4).

• Secure the connector and supports with locking bolts.

- Install the spindle (10 - 222 A /11) on slide and engine lifting eye.

- Tension the engine/transmission assembly by tightening the 3 spindles evenly.

Remove the Transmission Support:






• It is not necessary to remove the transmission support in order to remove the transmission mount.

- Remove the bolts - 1 and 2 -.

- Lower the engine/transmission assembly slightly with the spindles.

- Remove the transmission support - A -.

Transmission Mount, Removing:






- Open wiring guide bracket - arrows -.

- Cut the cable ties - 1 - and move the electric wires to the side.

- Unclip wiring guide.

- Remove the bolts - arrows -.






- Remove the bolts - 1 - and the transmission mount - A -.






Installing

Install in reverse order, paying attention to the following:

• For the correct tightening specifications, refer to => [ Subframe Mount Overview ] Subframe Mount Overview.

- Lift the transmission by the engine support bridge spindle until transmission support touches transmission mount support arm.






Risk of damaging the threads in the transmission support by inserting bolts crooked.

• Before installing bolts - arrows -, transmission support and transmission mount support arm must be absolutely parallel to each other. If necessary, raise rear of transmission with trolley jack.

- Remove subframe.

- Install the transmission mount support arm on transmission support.

- Remove (10 - 222 A) from engine.