02EA (S-Tronic) Transmission, (2.0L TFSI)

Transmission Mount and Transmission Support

Special tools, testers and auxiliary items required

• Engine Support Bridge (10 - 222 A)

• Bracket with Spindle and Hook (10 - 222 A /10)

Removing






- Remove the air filter housing.

- Remove the bolts - arrows - and remove the air filter housing bracket.

- Mount the (10 - 222 A) on the upper edges of the bolted fender flange as illustrated.






- Hook the spindle of the engine support bridge into the left engine lifting eye.

- Slightly tension the engine with the spindle, do not lift.

Remove the Transmission Support:






• It is not necessary to remove the transmission support in order to remove the transmission mount.

- Remove the bolts - 1 and 2 -.

- Lower the engine/transmission assembly slightly with the spindles.

- Remove the transmission support - A -.

Transmission Mount, Removing:






- Open the wiring guide bracket - arrows - and push the electric wires to the side.

- Unclip wiring guide.

- Remove the bolts - arrows -.






- Remove the bolts - 1 - and the transmission mount - A -.






Installing

Install in reverse order, paying attention to the following:

• For the correct tightening specifications, refer to => [ Subframe Mount Overview ] Subframe Mount Overview.

- Lift the transmission by the engine support bridge spindle until transmission support touches transmission mount support arm.






Risk of damaging the threads in the transmission support by inserting bolts crooked.

• Before installing bolts - arrows -, transmission support and transmission mount support arm must be absolutely parallel to each other. If necessary, raise rear of the transmission with trolley jack.

- Remove subframe.

- Install transmission mount support arm on transmission support.

- Remove (10 - 222 A) from engine.

- Install the air filter housing.