Suspension Control Module: Service and Repair

Electronic Damping Control Module (J250)

Removing






The electronic damping control module is installed under the right front seat.

- Remove the right front seat.

- Remove the right sill panel. Refer to "Trim, Coupe" or "Trim, Roadster".

- Fold up the carpet.

- Unclip the control module - 2 - - arrows -.

- Disconnect the connector - 1 - and remove the control module - 2 -.

Installing

Install in reverse order of removal. Note the following:

- If the electronic damping control module is replaced, the control position must be reprogrammed.

- Adapt the control position => [ Control Position Entry, Reprogramming with ] Testing and Inspection.