2.0L TT DSG

Starter

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Contact Corrosion.

Removing

• When installing, reinstall all cable ties that were loosened or cut during removal in the same locations.

- With ignition switched off, disconnect battery Ground (ND) wire. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove protective boot cable tie - arrow -.






- Disconnect electrical connector - 2 -.

- Fold protective boot - 1 - back and remove B+ wire from solenoid switch.

- Remove ground wire - 3 -.

- Remove lower starter bolt (accessible from above).

- Remove upper starter bolt and remove starter.

• Disregard item - 4 -.

Installing

• Tightening specifications. Refer to => [ Starter Overview ] Service and Repair.

Install in reverse order of removal. Note the following:

- Connect battery. Refer to => [ Connecting ] Battery, Disconnecting and Connecting.