Air Intake Grille

Air Intake Grille

- Remove the cover - B -. Refer to => [ Fresh Air Intake Cover ] Fresh Air Intake Cover.






- Remove nuts - C - (tightening torque 3.5 Nm).

- Remove the air intake grille - D -.

Installation is done is reverse order, observe the following:

• Make sure the seal on the bottom of the air intake grille is not damaged. If it is, replace it. This seal prevents water from flowing through beneath the intake grille into heating & A/C unit intake housing.

• Make sure the air intake grille - D - is properly seated, water may flow into intake housing of A/C unit if cover grille is not installed correctly.