Rear Lid Spoiler

Rear Lid Spoiler


• The adjusting elements and screws for securing the spoiler must always be replaced when replacing the spoiler.

• The water drain hoses must be replaced when removing and installing the drive unit.






1 Spoiler

• Removing

- Extend spoiler

- Remove bolts - 4 - and remove spoiler.

•

Installing:

• Two assistants are needed during installation to hold the spoiler even.

- The read lid trim panel is removed.

- Retract spoiler.

- Remove water drain hoses.

- Clip adjusting elements into spoiler

- Align intermediate piece according to adjusting elements and bond to spoiler.

- Insert spoiler in drive unit and align slides, top and bottom.

- With assistants, press spoiler in evenly and hold firmly.

- Open lid and tighten bolts - 4 - through water drain hose opening.

- Install water drain hose, ensuring it is seated correctly and does not leak.

2 Adjusting element

• Always replace.

• Clip into spoiler

• The adjusting elements are self-adjusting. That means height differences can be evened out by the adjusting elements.

3 Intermediate piece

• Self-adhesive

4 Bolt

• Always replace.

• 6 Nm

5 Spoiler motor

• Removing

- Rear lid trim removed.

- Remove water drain hoses.

- Disconnect electrical connectors.

- Remove nuts - 8 - and remove motor from lid.

• Installing:

- Installation is performed in the reverse order of removal.

• Motor mounting was changed.

• On the outer sides, motor is now secured with a cap nut which also serves as a centering device.

• New motors can be installed on old lids.

6 Water drain hose

• Always replace.

7 Clip

8 Nut

• The nut has been replaced with a cap nut, which also serves as a centering device

• 2 Nm

9 Stop

• Self-adhesive