From VIN 8E_8A 002700

Shift Lock Solenoid

Removing

- Remove selector lever handle. Refer to => [ Selector Lever Handle ] Selector Lever Handle.

- Remove selector mechanism cover - 1 -. Refer to => [ Selector Mechanism Cover ] Selector Mechanism Cover.





- Disconnect electrical harness connector on Shift Lock Solenoid (N110).

- Press retaining hooks - A - into shift mechanism - arrow - and hold it down.





• If retaining hook - A - is broken off, selector mechanism function unit must be replaced.

- Tip Shift Lock Solenoid (N110) down and out in direction of - arrow - so that ball head - 1 - disengages from operating lever on shift mechanism.





- Remove Shift Lock Solenoid (N110).

Installing

Install in reverse order, paying attention to the following:

- Rotate ball head - 1 - to correct installation position.

- Guide Shift Lock Solenoid (N110) diagonally from above into shift mechanism.

- Tip Shift Lock Solenoid (N110) down in opposite direction of - arrow -.

- Ball head - 1 - must be completely engaged in operating lever on shift mechanism.





- Secure Shift Lock Solenoid (N110) with the retaining hook - A -.

- Install selector mechanism cover - 1 -. Refer to => [ Selector Mechanism Cover ] Selector Mechanism Cover.

- Install selector lever handle. Refer to => [ Selector Lever Handle ] Selector Lever Handle.

- Check shift lock solenoid (N110) function. Refer to => [ Selector Mechanism, Checking ] Procedures