Plenum Chamber E-Box 4-Way Relay Carrier

Plenum Chamber E-Box 4-Way Relay Carrier

Removing

CAUTION!
• Switch off all electrical consumers.

• Switch ignition off and remove ignition key.

- Remove rubber seal of plenum chamber cover in direction of - arrow -.





- Remove plenum chamber cover - 1 - to front.

- Use screwdriver to pry off the two caps - 3 -.





- Loosen nuts - 4 - (do not remove).

- Remove wiper arms - 2 - from wiper shaft by tilting slightly.

- Remove nuts completely and remove wiper arms.

- Pull off retaining clips - 1 - and detach cowl panel grille - 5 -.

- Remove cover for electronics box in plenum chamber - arrows -.





- Use screwdriver to pry off retaining strap - arrows -.





- Lay aside engine control module with wires attached.

- Where applicable, release the retaining clip for the transmission control module.

- Lay aside transmission control module with wires attached.

- Release retaining clips - arrows - and lift auxiliary relay carrier out of electronics box.





- Unclip the fuse carriers at the 4-position relay carrier.

- Remove relays and control modules and then unclip appropriate relay carrier.

• Refer to the applicable wiring diagram for exact identification of connections on electronics box => Wiring Diagrams.





Installing

Install in reverse order of removal.