Oil Filter: Service and Repair

Engine Oil, Draining and Replacing Oil Filter

WARNING! Oil extraction not permitted with various engine types!

Note:
- Perform oil change at operating temperature.

Special tools and workshop equipment required
- Oil Extractor -VAG 1782-
- Hazet Tension Band -2171-1-
- Oil Filter Wrench -3417-
- Oil Drain Adapter -T 40057-
- 2.0 TFSI Engine Code CCTA and CBFA
- 2.0 FSI and 2.0 TFSI Engine Code BPY
- 3.2L MPI
- TDI PD engines
- CR TDI engines

Note:
- Observe waste disposal regulations!

2.0 TFSI CCTA and CBFA

- Remove the noise insulation. Service and Repair



- Loosen oil filter with -2171-1- or -3417- and remove.

Note:
- Observe waste disposal regulations!

- Open oil drain plug or extract engine oil.
- Clean oil filter sealing surface on engine.
- Lubricate rubber seal lightly with oil.
- Install new filter and tighten.
- Install oil drain plug with new gasket.
- Fill with engine oil.

Tightening Specifications
Oil filter 22 Nm
Oil drain plug 30 Nm