Subframe Mount Adjustment, Checking

Subframe Mount Adjustment, Checking

Work procedure





- Pull EVAP canister with connected lines upward in direction of - arrow - out of retainer and lay it aside.

Proceed as follows:

- Check dimensions on right mount for engine and transmission:





^ Both bolt heads - 2 - must be parallel to edge of engine mount support arm - 3 -.
^ A distance of - x - = 16 mm must be present between engine mount - 1 - and engine support - 4 -.

Note:
^ Distance - x - = 16 mm can also be checked with corresponding round stock.

- If distance is too small or too large, subframe mount must be adjusted.