Plenum Chamber E-Box Connector Junction

Plenum Chamber E-Box Connector Junction

Removing

- Disconnect battery. Audi A4 & S4=> [ Battery, Engine Compartment, Disconnecting and Connecting ] Battery, Engine Compartment, Disconnecting and Connecting. Audi RS4 => [ Battery, Luggage Compartment, Disconnecting and Connecting ] Battery, Luggage Compartment, Disconnecting and Connecting.

- Where applicable, remove driver's storage compartment.

- Remove electrical wire at bottom of connector point in plenum chamber electronics box.

- Remove rubber seal of plenum chamber cover in direction of - arrow -.





- Remove plenum chamber cover - 1 - to front.

- Use screwdriver to pry off the two caps - 3 -.





- Loosen nuts - 4 - (no not remove).

- Remove wiper arms - 2 - from wiper shaft by tilting slightly.

- Remove nuts completely and remove wiper arms.

- Pull off retaining clips - 1 - and detach cowl panel grille - 5 -.

- Remove cover for electronics box in plenum chamber - arrows -.





- Use screwdriver to pry off retaining strap - arrows -.





- Lay aside engine control module with wires attached.

- Release retaining clip for transmission control module.

- Lay aside transmission control module with wires attached.

- Disconnect electrical connections at rear of connector console.

Vehicles through 10.04:

- Remove electrical wire - 2 -.





- Remove screws - 1 - and - 3 -.

- Unclip appropriate socket.

• Refer to the applicable wiring diagram for exact identification of connections on connector station => Wiring Diagrams.





Vehicles from 11.04:

- Remove electrical wire - 3 -.





- Remove screws - 2 - and - 4 -.

- Unclip appropriate socket - 1 -.

• Refer to the applicable wiring diagram for exact identification of connections on connector station => Wiring Diagrams.





Installing

Install in reverse order of removal, noting the following:

- Reconnect battery. Required steps Audi A4 & S4 => Battery, Engine Compartment, Disconnecting and Connecting. Required steps Audi RS4 => Battery, Luggage Compartment, Disconnecting and Connecting.

Tightening Specifications