Clutch Pedal Switch F36, Removing and Installing

Clutch pedal switch F36, removing and installing - 6 Spd. Manual Transmission 02X All Wheel Drive

Note:
^ Clutch pedal switch may only be installed once so as to ensure a secure fit.

Removing

- Remove storage compartment on drivers side.





- Disconnect electrical connector - 1 - on clutch pedal switch.

^ The clutch pedal - 3 - is in the normal position (i.e. not pressed down). The operating rod - arrow - of clutch pedal switch should then rest against clutch pedal.

- Release clutch pedal switch - 2 - by turning 45 degrees counter-clockwise and remove from guide.

Installing





Installation is in reverse order of removal. Note the following:

- Pull out operating rod - arrow - all the way before installing clutch pedal switch.





^ The clutch pedal should be in the normal position (i.e. not pressed down).

- Guide clutch pedal switch through mounting hole, press against clutch pedal and attach by turning 45 degrees clockwise.
- Connect connector for clutch pedal switch.
- Install storage compartment on drivers side.