Seat Bench, Removing and Installing

Seat Bench, from 11.04, Removing and Installing

Removing







- Remove Seat Bench upward at front edge and out of mounting - 1 - on left and right side.
- Disengage Seat Bench from mounting - 4 - on left and right, forcefully push Seat Bench backward to do so.
- On vehicles with seat heaters, lift Seat Bench far enough so that electrical harness connectors can be disconnected.
- Remove electrical harness connector for side airbag from groove.
- Remove seat bench from vehicle.

Installing

- Installation is reverse of removal. Observe the following when doing so:

CAUTION: Mountings must be replaced after each removal of Seat Bench.







Side airbag cable connector

CAUTION: Observe safety precautions for work on airbags.







Replacing mountings

- Remove used mounting from chassis cut-out.
- Insert new mounting grommet - 2 - into body cut-out until it clicks into place - 1 -.