Seat, Removing and Installing

Seat, Removing and Installing

Special tools, testers and auxiliary items required







- Torque wrench V.A.G 1332

NOTE:
- The RS sport seat has no side airbag. Therefore, the electrical connection for the side airbag must have a terminal resistance in the wiring harness.
- Depending on the version, this terminal resistance is securely connected to the wiring harness, or is designed as a separate connector housing with terminal resistance.







1 - Front seat

Removing
- Push front seat - 1 - fully upward and to the rear.
- Remove front bolts - 3 - (Qty. 2).
- Move seat forward.
- Loosen seatbelt eyelet at outer anchoring point for seat and remove seatbelt from belt guide.
- Remove rear bolts - 4 - (Qty. 2).
- Tip front seat - 1 - back.
- Disconnect electrical harness connector.

Installing
- Installation is reverse of removal.

2 - Seat rail covers
- Right front and left rear are identical
- Left front and right rear are identical
- Removing and installing

3 - Front bolts (2x)
- Tightening torque 50 Nm

4 - Rear bolts (2x)
- Tightening torque 50 Nm