Gas-Filled Strut, Avant

Gas-Filled Strut, Avant

Removing

- Prop up and secure rear lid in open position.

- Using screwdriver, lift retaining spring - 3 - as shown and remove gas-filled strut - 1 - from upper ball stud - 2 -.





• Following complete removal of the gas-filled strut, check for correct positioning during installation.

• Sound insulation component must be installed on the body side.

•

Installing

Installation is the reverse of removal, noting the following:

- To install, press gas-filled strut onto ball studs so that it engages in position.

- Ball stud tightening torque: 15 Nm-1 Nm