Selector Shaft Oil Seal, Replacing

Selector shaft oil seal, replacing - 09L, 6 Speed AWD A/T

Special tools, testers and auxiliary items required





^ Removal lever 80-200





^ Thrust piece T10135

Procedure

Note:
^ General repair instructions.
^ Read the rules for cleanliness when working on the automatic transmission.

- Shift selector lever to position "P".
- Remove transmission support (left-side).





- Use removal lever 80-200 to pry ball socket - 1 - on selector lever cable off selector shaft lever.

Note:
^ Do not bend or kink the selector lever cable.
^ - Item 2 - can be disregarded.





- Drive out roll pin - 1 - at selector shaft lever - 2 - - arrow - until it is possible to detach selector shaft lever from selector shaft.





- Push a small screwdriver through seal and pull it out.
- Lubricate outer circumference and the space between sealing lips of seal with ATF.
- Install new seal onto selector shaft.

^ Installation position: open side of seal faces transmission.





- Press on new oil seal using thrust piece T10135 and assembly lever - A - as far as stop; make sure that oil seal remains straight.

Note:
^ To prevent slippage when pressing in oil seal, place something as a base (e.g. piece of rubber) between assembly lever and subframe - arrow -.

- Before installing, drive roll pin in selector shaft lever back through lever in opposite direction.
- Push selector shaft lever onto selector shaft and drive in roll pin.





- Press selector lever cable - 1 - onto selector shaft lever - 3 -.

Note:
^ Do not bend the selector shaft lever when pressing on the ball socket, as otherwise it will no longer be possible to precisely adjust the gear selector mechanism

^ - Item 2 - can be disregarded.

- Check ATF level.