Steering Column Switches

Airbag Spiral Spring/Return Spring With Slip Ring

Special tools, testers and auxiliary items required

• T8 Screwdriver (T40056 A)

Removing

• Steering must be in center position (wheels in straight ahead position) when removing and installing coil connector with slip ring.

- Lower steering wheel as far as possible to rear, making use of the full range of the steering column adjuster.

- Remove airbag unit.

- Remove steering wheel.

- Remove bolts - 3 - and - 5 - using T8 screwdriver (T40056 A).





- Remove the inner hex bolt - 4 -.

- Separate top trim - 2 - for steering column switches from bottom trim - 1 - and remove both parts.

- Disconnect upper electrical harness connector at return spring with slip ring.





- Carefully release fasteners - arrows - and pull Airbag Spiral Spring/Return Spring With Slip Ring - 1 - off steering column switch module.

• Steering column switch module has been removed in illustration.

Installing

Install in reverse order of removal, observing the following:

- Make sure all fasteners and electrical connectors are properly engaged.

- Insert top trim piece for steering column switch into catches of bottom trim piece, press together and bolt.

- Install steering wheel.

- Install airbag unit.

Tightening Specifications