Triple Roller Joint AAR 2000 Outer CV Joint, Servicing

Triple Roller Joint AAR 2000 Outer CV Joint, Servicing

Disassembling outer CV joint

- Secure drive axle with protective covers in vise clamp.

- Remove clamp and slide boot back.

- Screw Pressure Spindle (3207) with M 16/M 14 thread version into joint pins until CV joint is press off of drive axle.





- Remove circlip

Outer CV joint, installing

- Slide joint protective boot onto drive axle.

Protective boot and boot seat on drive axle must be free of grease.

- Install new circlip

Circlip (snap ring) must be replaced.

- Apply 50 g joint grease in inside of joint.

- Before installing joint or triple roller star, splines - A - must be lightly coated with grease used in joint.





- Screw old drive axle bolt into joint as shown in the illustration.





- Drive joint onto drive axle with plastic hammer until circlip engages.

- Apply 40 g joint grease in boot side of joint.

Grease quantities, see table => [ Grease quantity and type ] Triple Roller Joint AAR 2000 Assembly Overview

- Bleed protective joint boot.

- Close clamp.