On Board Diagnostic

Fig. 11 Hydraulic Unit - 01J, Continuously Variable Transmission (CVT)

Component location: The hydraulic unit is bolted to the rear of the transmission. The Transmission Control Module (TCM) - J217 - is bolted directly to the hydraulic unit.

A - Wiring connector for Pressure control valve 1 for automatic transmission - N215 -

A - Wiring connector for Pressure control valve 2 for automatic transmission - N216 -

C - Wiring connector for solenoid valve 1 - N88 -

The following valves are integral on the hydraulic unit (not shown here):

1 - Pressure control valve 1 for automatic transmission - N215 -; clutch solenoid valve

2 - Pressure control valve 2 for automatic transmission - N216 -; transmission ratio solenoid valve

3 - Solenoid valve 1 - N88 -; clutch cooling/safety cutoff

4 - Clutch cooling valve

5 - Minimum pressure valve

6 - Pressure control valve

7 - Clutch control valve

8 - Control pressure valve