Selector Lever Cable and Locking Cable (Through VIN 8E_6A156499), Assembly Overview

Selector lever cable and locking cable (through VIN 8E_6A156499), assembly overview - 01J, Continuously Variable Transmission (CVT)

Note:
^ Do not bend or kink the selector lever cable.
^ Lightly grease eyelet and ball socket with polycarbamide grease G 052 142 A2 before installing.





1 - Nut

^ 23 Nm

2 - Selector lever cable

^ Do not bend or kink, lightly grease cable eye and ball socket before installing.
^ Adjusting Selector lever cable (through VIN 8E_6A156499), adjusting
^ In case of damaged rubber boots, selector lever cable must be replaced
^ When installing, make sure that rubber sleeve on transmission side is not twisted

3 - Lock nuts

^ 13 Nm

4 - Boot for selector lever cable

^ To be buttoned into selector mechanism bottom cover

5 - Retaining clip
6 - Ignition/starter switch with ignition key removal lock
7 - Locking cable

^ For ignition key removal lock
^ Not to be kinked
^ Adjust

8 - Bolt

^ 9 Nm

9 - Clamping screw

^ 13 Nm
^ For selector lever cable
^ Loosen 1 turn for adjusting, do NOT remove completely

10 - Pin

^ For selector lever cable
^ To remove selector lever cable, move plastic retaining spring at selector mechanism forward slightly and put screws upward, only as far as necessary.

11 - Retaining clip for selector lever cable
12 - Bracket for selector lever cable
13 - Bolt

^ 23 Nm

14 - Bracket for selector lever cable