Selector Lever Cable and Locking Cable (From VIN 8E_6A156500), Assembly Overview

Selector lever cable and locking cable (from VIN 8E_6A156500), assembly overview - 01J, Continuously Variable Transmission (CVT)

Note:
^ Do not bend or kink selector lever cable.
^ Lightly grease eyelet and ball socket with polycarbamide grease G 052 142 A2 before installing.





1 - Selector lever cable

^ Do not bend or kink, lightly grease cable eye and ball socket before installing.
^ In case of damaged rubber boots, selector lever cable must be replaced
^ When installing, make sure that rubber sleeve on transmission side is not twisted

2 - Lock nuts

^ 13 Nm

3 - Retaining clip
4 - Ignition/starter switch

^ With ignition key removal lock

5 - Locking cable

^ For ignition key removal lock
^ Not to be kinked

6 - Bolt

^ 9 Nm

7 - Clamping screw

^ 13 Nm
^ For selector lever cable
^ Loosen 1 turn for adjusting, do NOT remove completely

8 - O-Ring

^ Always replace

9 - Retaining clip for selector lever cable
10 - Bolt

^ 20 Nm
^ For securing bracket to selector lever cable bracket

11 - Bracket for selector lever cable

^ Different equipment depending on version

12 - Bolt

^ 20 Nm
^ Qty. 3
^ For securing selector lever cable bracket to transmission

13 - Bracket for selector lever cable

^ Different equipment depending on version