FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Locking Lever (From VIN 8E_6A156500), Removing and Installing



Locking lever (from VIN 8E_6A156500), removing and installing - 01J, Continuously Variable Transmission (CVT)

Overview





1 - Locking cable
2 - Retaining clip
3 - Locking cable eye pins
4 - Locking cable bracket
5 - Bolt, 10 Nm

^ For adjusting locking cable

Removing

Note:
^ Do not kink locking cable.

CAUTION!
Observe procedures for disconnecting battery.


- Disconnect Ground (GND) wire at battery.
- Remove storage compartment on drivers side.
- Remove steering column trim.
- Remove A/C system operating unit.
- Remove ashtray in center console.
- Remove cover for shift mechanism.
- Turn ignition key into driving position "ignition on".
- Place selector lever in position "P".





- Lift retaining clip - 2 - from interlock lever and pull locking cable - 1 - out of ignition/starter switch.





- Raise retaining tab - A - and remove locking lever in direction of - arrow - from locking cable eye pins.

Installing

Installation is in reverse order of removal, note the following:





- Route locking cable without kinks under wiring harness - arrow A - and behind instrument panel brace - arrow B -.
- Turn ignition key into driving position "ignition on".





- Insert locking cable - 1 - into ignition/starter switch.
- Check interlock lever - 2 -.
- Bring ignition/starter switch into locking position "ignition off".
- Check whether selector lever is in position "P".





- Slide locking cable in opposite in direction of - arrow - onto locking cable eye pins.

^ The retaining tab - A - must engage over locking cable

- Adjust locking cable.
- Observe procedures for connecting battery.