Input Shaft Adjustment, Air Gap, Checking

Input Shaft Adjustment, Air Gap, Checking - 01J, Continuously Variable Transmission (CVT)

CAUTION!
Do not allow engine to run without filling ATF and do not tow the vehicle.

^ ATF filled

- Drive vehicle off hoist.

Note:
^ On vehicles with air suspension, vehicle lifting mode must be deactivated.

^ ATF filled

- Place vehicle on level surface.

Note:
^ With parking brake released, vehicle may roll forward or backward by itself when in selector lever position "N".

- Start engine.
- Place selector lever in position "N".

^ Do not engage parking brake.
^ Do not operate brake pedal.

- Press accelerator.

^ Vehicle should not be allowed to roll.

If vehicle rolls in selector lever position "N":

- Adjust selector lever cable

If selector lever cable adjustment is OK but vehicle still rolls in selector lever position "N":

- Input shaft, servicing see Input Shaft, Servicing with 6 Lining Discs or Servicing with 7 Lining Discs Input Shaft, Servicing With 6 Lining Discs

Note:
^ In this case, input shaft adjustment (air gap) was not performed correctly.

If vehicle does not roll in selector lever position "N":

The input shaft adjustment with evaluation of air play is OK.

- Carry out ATF flush.