Cleaning Selector Shaft

Cleaning Selector Shaft - 01J, Continuously Variable Transmission (CVT)

Note:
^ Observe general repair notes.
^ Rules of cleanliness for working on automatic transmissions.

Procedure

- Remove end cover.
- Remove Transmission Control Module (TCM) J217.





- Clean catch - arrow - of selector shaft. Do not use fluffy materials for cleaning. Clean contact surfaces of magnet especially thoroughly of metal shavings and the like.

Note:
^ Make sure that spring - A - and roller - B - are secured properly.

- Check roller - B - and spring - A - for damage; replace if necessary.





- If necessary, clean sensors - A -, - C - and - D - of contamination and metal shavings.
- Install Transmission Control Module (TCM) J217.
- Install end cover.