01J,0AN Continuously Variable Transmission

Selector Shaft Seal

Special tools, testers and auxiliary items required

• Tube (VW 418 A)

Procedure

• Transmission removed.

- Remove bolt - B - completely and remove lever for selector shaft - A - upward.





CAUTION!
Danger of damaging the selector shaft, illustrated here with the hydraulic control unit removed.

• The selector shaft must not be pushed into or pulled out of the transmission.

• The shifting cam - 1 - on the selector shaft will break off if the selector shaft is forced up or down.

• The transmission must be replaced if the shifting cam is damaged.







- Carefully pry selector shaft seal lying below out with screwdriver.

• Sealing surface and selector shaft must not be damaged.

- Coat outer circumference of new shaft seal with ATF.

- Slide on new shaft seal over selector shaft and press in.

- Drive in shaft seal until it stops using tube ( VW 418 A).

- Connect lever for selector shaft - A - to selector shaft and tighten bolt - B -.

Tightening Specifications