Selector Shaft Seal

Selector Shaft Seal - 01J, Continuously Variable Transmission (CVT)



Special tools, testers and auxiliary items required

^ Tube VW 418 A

Procedure

^ Transmission removed.





- Remove bolt - B - completely and remove lever for selector shaft - A - upward.

CAUTION!
Danger of damaging the selector shaft, illustrated here with the hydraulic control unit removed.
^ The selector shaft must not be pushed into or pulled out of the transmission.
^ The shifting cam - 1 - on the selector shaft will break off if the selector shaft is forced up or down.
^ The transmission must be replaced if the shifting cam is damaged.





- Carefully pry selector shaft seal lying below out with screwdriver.

Note:
^ Sealing surface and selector shaft must not be damaged.

- Coat outer circumference of new shaft seal with ATF.
- Slide on new shaft seal over selector shaft and press in.
- Drive in shaft seal until it stops using tube VW 418 A.
- Connect lever for selector shaft - A - to selector shaft and tighten bolt - B -.

Tightening Specifications