Right Flange Shaft, Removing and Installing

Right flange shaft, removing and installing - 01J, Continuously Variable Transmission (CVT)

Special tools, testers and auxiliary items required

^ Oil receptacle

Removing

^ Transmission installed.

- Remove right front wheel.





- On vehicles equipped with auxiliary heater, remove bolts - arrows - for exhaust pipe of auxiliary/additional heater to noise insulation.





- Remove bolts or quick-release screws - 1 to 3 - and remove noise insulation at front and rear.





- Where installed, remove bolt - 1 - for noise insulation cover over right drive axle.
- Disengage hook - 2 - and remove noise insulation cover.
- Remove heat shield for right drive axle.
- Remove right drive axle.





- Remove mounting bracket for flange shaft - arrows -
- Place an oil receptacle underneath transmission.
- Pull out right flange shaft together with mounting bracket.

Installing

- Clean flange shaft.
- A damaged sealing ring must be replaced.





- Replace O-ring - arrow A - in mounting bracket for flange shaft.
- Slide spring - C - with cap outward into hole on end of flange shaft - arrow -.
- Insert flange shaft - B - into transmission housing.

Note:
^ While sliding in the flange shaft, make sure that spring - C - remains in the flange shaft and does not fall into transmission.





- Tightly bolt mounting bracket for flange shaft - arrows -.
- Install right drive axle.
- Check gear oil level in front final drive.

Torque specifications