Starter, 2.0L Turbo FSI

Starter, 2.0L Turbo FSI

Special tools, testers and auxiliary items required

• VAG 1331 Torque wrench (or 5 - 50 Nm equivalent)

• VAG 1332 Torque wrench (or 40 - 200 Nm equivalent)

Removing

- Disconnect battery => [ Battery, Engine Compartment, Disconnecting and Connecting ] Battery, Engine Compartment, Disconnecting and Connecting.

- Lift vehicle.

- Release fasteners - 1 - and - 2 - and remove front noise insulation.





- Remove heat shield - 1 - for right drive shaft.





- Remove bolts - 1 - and - 2 -.





- Remove starter and swing aside.





- Disconnect electrical connection for terminal 50 - 3 -.

- Remove nut - 1 - for harness clamp.

- Remove nut at starter solenoid terminal B+ - 2 - and remove connector eyelet from terminal.

- Remove starter.

Installing

Install in reverse order of removal, noting the following:

- Reconnect battery. Required steps => Battery, Engine Compartment, Disconnecting and Connecting.

Tightening Specifications