Fuse Holder

Fuse Holder

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Contact Corrosion.

Removing





- With ignition switched off, disconnect battery Ground (GND) wire. Refer to => [ Battery, Disconnecting and Connecting ] .

- Remove driver's storage compartment.

- Remove bolts - 1 - of fuse panel - 2 -.

- Remove fuse panel from central tube for instrument panel.

- Unhook wiring harness on central tube for instrument panel and set aside.

- Cut cable tie - 1 -.





- Release cover for fuse panel - arrows -.

- Remove fuses on fuse panel.

- Remove retaining strip for the connectors - arrows - and remove the connectors from fuse panel.





- Unclip socket - 1 -.

• Check the exact assignment for fuse panel in the current wiring diagram Wiring diagrams, Troubleshooting & Component locations.

Installing

Install in reverse order of removal, observing the following:

• All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.

- Connect battery. Required actions => .

- Install driver's storage compartment.

Tightening Specifications