FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Three-Point Seat Belt With Height Adjuster






Three-Point Seat Belt with Height Adjuster

Special tools, testers and auxiliary items required

Torque Wrench (V.A.G 1331)





Torque Wrench (V.A.G 1332)









1 Belt

Removal:

CAUTION!
Observe measures when disconnecting battery.

- Disconnect battery.

- Loosen upper A-pillar trim to B-pillar trim. Refer to => [ Upper A-Pillar Trim ] Trim.

- Loosen upper D-pillar trim to B-pillar trim. Refer to => [ D-Pillar Trim ] Trim.

- Remove upper B-pillar trim. Refer to => [ Upper B-Pillar Trim ] Trim.

- Remove lower B-pillar trim. Refer to => [ Lower B-Pillar Trim ] Trim.

- Loosen seat belt eyes - 2 - on outer seat anchorage point.

- Loosen belt - 1 - from guide - 5 -.

- Note anti-twist mechanism, loosen bolt - 4 - and remove belt tensioner - 3 -.

- Remove bolt - 7 - on top of belt height adjuster - 6 - and loosen belt - 1 - from height adjuster.

- If complete remove of the belt height adjuster - 6 - is desired, loosen bolt - 8 - on height adjuster.

- Open yellow retainer on yellow-blue connector - 9 - with a screwdriver and disconnect connector.

Installing:

- Install belt webbing rotated by 180° - arrow - -as shown in illustration-.

- Arrow - A - faces in direction of travel.

- Ensure connector - 9 - is engaged correctly.

- Remaining installation is in reversed sequence.

After installing passenger side three-point seatbelt, check belt function for child seat. Refer to => [ Child Seat Anchorage, Checking Function ] Seat Belts, Inspecting.

The three-point seat belt must not be impeded by cables, wires, insulation, etc.

Follow measures after connecting battery.

2 Outer Seat Belt End Anchorage Point Eyelets

3 Belt Tensioner

4 Bolt

Tightening specification 55 Nm

5 Guide

6 Belt Height Adjustment

Removal:

- Remove upper B-pillar trim - 5 -. Refer to => [ Upper B-Pillar Trim ] Trim.

- Remove bolt - 7 - and bolt - 8 -.

- Remove belt height adjuster - 6 - upward.

Installing:

To install, perform the steps used in removal in reverse order.

Button - 10 - must not be pressed during installation.

Function test after installing trim:

Height adjuster must audibly engage into all five possible positions (even top position).

Button must return by itself to upper position after being actuated.

7 Bolt

Tightening specification 55 Nm

Belt relay must swing by itself in carrier direction after tightening screw.

8 Bolt

Tightening specification 23 Nm

9 Connector

10 Height Adjustment Button