Belt Latch, Standard and Memory Seat

Belt Latch, Standard and Memory Seat

CAUTION!
Observe safety precautions. Refer to => [ Pyrotechnic Belt Tensioners Safety Precautions ] Technician Safety Information

- Remove seat:

• There are 2 versions of the safety belt latch. Both versions are described in the following. Determine which version the vehicle has and performed the corresponding activities.

Version 1

Removing

- Remove the bolt - 2 - for safety belt latch - 1 -.





Vehicles with seatbelt fasten sensor and switch in safety belt latch (driver's side only, for certain countries):

- Remove cable from red connector housing.

- Using a screwdriver, pry out retaining hooks - 4 - on red connector housing - 1 -.





- Press red connector housing - 1 - back.

- Cable pin - 6 - (Qty. 2) for belt fasten sensor.

- Red connector housing - 1 - for belt fasten sensor and main voltage supply.





- Release cable retainer - 2 - in direction of - arrow - by prying out at cut-out - 3 -.

The illustration shows the released cable retainer - 2 -.

- Remove cable - 4 - for belt fasten sensor from sockets 5 and 6 and on the driver's side (in certain countries), the cable - 4 - for the switch in safety belt latch socket 1 and 2 as well.

- Open cable ties.

Installing

CAUTION!
Observe safety precautions. Refer to => [ Pyrotechnic Belt Tensioners Safety Precautions ] Technician Safety Information

Installation is performed in reverse order of removal, noting the following.

- Replace the bolt on the safety belt latch.

Tightening Specifications





Version 2

Removing

CAUTION!
Observe safety precautions. Refer to => [ Pyrotechnic Belt Tensioners Safety Precautions ] Technician Safety Information

- If present, disconnect connector - 1 - under seat equipment versions.





- If present, remove cable from clip - 2 - equipment versions.

- Remove the bolt - 3 -.

- Remove safety belt latch - 4 -.

Installing

CAUTION!
Observe safety precautions. Refer to => [ Pyrotechnic Belt Tensioners Safety Precautions ] Technician Safety Information.

Installation is performed in reverse order of removal, noting the following.

- Replace the bolt on the safety belt latch.

Tightening Specifications