Convertible Top Hydraulic Solenoid Valve

Convertible Top Hydraulic Solenoid Valve

Removing





Follow cleanliness rules => [ Convertible Top Hydraulic System Clean Working Conditions ] Convertible Top Hydraulic System Clean Working Conditions.

- Remove hydraulic pump => [ Convertible Top Hydraulic Unit and Pump ] Convertible Top Hydraulic Unit and Pump.

- Remove bolts - 3 -.

- Remove solenoid valve - 2 - upward out of hydraulic pump - 1 -.

Installing

CAUTION!
Solenoid valves may only be installed in hydraulic pump in activated (energized) condition. Initiate output diagnostic test mode (DTM) and activate the affected solenoid valve for this.

- Connect electrical harness connector - 1 - to solenoid valve - 2 -.





- Initiate output diagnostic test mode and activate solenoid valve to be installed.

- Insert activated solenoid valve - 2 - in hydraulic pump - 3 -.

- Tighten bolts - arrows -.

Tightening torques => [ Convertible Top Hydraulic System Assembly Overview ] Convertible Top Hydraulic System Assembly Overview.