Resetting Without Vehicle Diagnosis Tester

1. Insert key into ignition






2. Push in the service button (with the crescent wrench icon), just left of the odometer reset button, hold it in, and turn ignition ON without starting engine.

3. The display should read either "SERVICE IN ????Miles" or "Service!" if it does not, repeat steps #1 and #2.

4. To reset, push and hold the odometer reset button until you see "SERVICE IN --- MILES --DAYS" or "SERVICE!"..

5. Turn the ignition off. If done correctly, when the ignition is turned back on, the "Service!" reminder will not show.

Note:
Perform step #4 before the "Service!" message disappears and changes to the usual message about holding the brake down while shifting out of Park.
Do not reset the display between service intervals. Doing so will result in an incorrect display.
The service display information will remain intact even if the battery is disconnected.
If a priority 1 malfunction is detected (red symbol), you cannot display the distance remaining.