Ribbed Belt, Component Overview

Ribbed belt, component overview

Note:
^ Before removing ribbed belt, mark the turning direction on it with chalk or a felt tip pen. A reversed turning direction can cause damage to the belt under operating conditions. When installing, make sure the belt is correctly seated in the belt pulley.





1 - Ribbed belt

^ Ribbed belt routing
^ Check for wear
^ Do not kink

2 - Pulley

^ For ribbed belt

3 - Special bolt

^ Replace
^ Torque specification 10 Nm plus an additional 90 degrees

4 - 23 Nm

5 - Engine lift eye

6 - Belt tensioner for ribbed belt

^ To release tension on ribbed belt, pivot using open-end wrench.
^ Secure tensioner with special tool Locking Tool T40098

7 - 23 Nm

8 - Bushing

9 - Bracket for assemblies

10 - 23 Nm

11 - Generator

^ To facilitate installing the generator, slightly drive back threaded bushings for retaining bolts on generator.

12 - 23 Nm

13 - Power steering pump

14 - 45 Nm

^ Insert with locking fluid
^ Locking fluid
^ Observe tightening sequence

15 - Bushing

^ 2 pieces

16 - Air conditioner compressor

17 - 25 Nm

18 - Idler roller for ribbed belt

^ Note installation position

19 - 20 Nm plus an additional 90 degrees (1/4 turn)

^ Replace