Crankshaft Belt Pulley, Removing and Installing

Crankshaft belt pulley, removing and installing

Removing





- For vehicles with auxiliary heater, remove bolts - arrows - for exhaust pipe of parking heater/auxiliary heater on noise insulation.





- Loosen quick-release fasteners -1- and -2- and remove front noise insulation.
- Bring lock carrier into service position. Service and Repair
- Remove ribbed belt





- Unfasten crankshaft belt pulley.

Note:
^ To loosen and tighten the crankshaft belt pulley, counter-hold at the central bolt using a box-end wrench.

Installing

Installation is in reverse order of removal, note the following:





- Only install crankshaft belt pulley with original bolts

^ Only possible to install in one position: The hole - arrow - in crankshaft belt pulley must be positioned over protrusion on toothed belt sprocket

- Install lock carrier with attachments. Service and Repair





- Place torque support stop onto rubber buffer for torque support under its own weight and tighten nuts - arrows -.
- Install front bumper cover.
- Check headlight adjustment.

Torque specifications