C38

Brake calipers, servicing

Rear brakes with automatic adjustment

Note:
^ Install all parts supplied in repair kit.





1 - Brake disc

^ Always replace both sides
^ Remove brake caliper prior to removing
^ Tighten evenly, on both sides, starting from thickness when new

2 - Ribbed bolt, 75 Nm

^ M10�1.25 x 60
^ Always replace
^ Use socket T40027

3 - Brake carrier with guide pins and protective caps

^ Replacement carriers are supplied assembled and with sufficient grease on guide pins
^ If protective caps or guide pins are damaged, replace using repair kit. Use grease packet supplied to lubricate guide pins.

4 - Ribbed bolt, 75 Nm

^ Always replace
^ M10�1.25 x 50

5 - Brake pads

^ Always replace both sides

^ Checking pad thickness.

6 - Brake disc cover

7 - Collar bolt, 10 Nm

^ M6�12

8 - Self-locking bolt, 35 Nm

^ Always replace
^ When loosening and tightening, counter-hold on guide pin

9 - Brake caliper housing

^ Do not disconnect brake hose when changing brake pads
^ Servicing brake calipers

10 - Wheel bolts

^ Installing wheels

11 - Torx bolt

^ Tightening torque: 5 Nm