Hood Shock / Support: Service and Repair

Gas-filled Strut, Removing And Installing







- Support hood or secure it from falling down.
- Gently lift retaining springs - arrow - at both ends of gas-filled strut using a screwdriver and unclip gas-filled strut.
- To install, press gas-filled strut onto ball stud and engage.
- Install with tube end of strut at body.







Gas-filled strut, venting

CAUTION: Clamp only within this area, otherwise accident could occur.

- Clamp gas-filled strut in vice area - x - = 50 mm (2 in.).
- Cover area of sawn portion with a rag to absorb oil spraying out.

CAUTION: Always wear eye protection when performing this procedure.

- Cut through cylinder of gas strut within first third of cylinder's overall length using piston rod end of cylinder as reference point.