Hood Cable, Removing and Installing

Hood Cable, Removing And Installing







1 - Hood cable

- Removing:
- Remove front wheelhousing liner.
- Remove storage compartment on drivers side (vehicles with knee bolster): Body Interior - Repair Group 68. or Vehicles without knee bolster: Body Interior - Repair Group 68
- Remove bolt.
- Remove retaining clip.
- Unclip cable for lower part of hood lock and disengage attachment lug - arrow A -.
- Remove cable from retaining clips opened earlier and pull into wheelhousing toward lock carrier.

- Install in reverse sequence.
- Bring ball on cable for lower part of hood lock into installation position.

2 - Operating lever
3 - Screw
- 2.4 Nm

4 - Retaining clamp
5 - Lower part of hood lock
- Removing and installing
- Can be used to adjust height of hood.

6 - Retaining clip