Front Bumper Crossmember to Impact Absorber Mount

Front Bumper Crossmember to Impact Absorber Mount

• Impact absorber is self-adjusting, meaning it can compensate bearing tolerances in height between crossmember and Impact absorber when installing the bolt.

• This holds and secures the crossmember automatically in the previously adjusted position when installing the bolt - 1 -.





1 Screw

• 23 Nm

2 Lower carrier bushing

• Plastic part pressed into adjusting screw.

• No replacement part.

3 Lower adjusting screw

• Before assembling bumper crossmember, install completely but do not tighten.

• Left-hand thread

• No replacement part.

4 Lower threaded bushing

• Secured against falling out with securing pin.

• No replacement part.

5 Securing pin

• No replacement part.

6 Impact absorber

• Removing and installing => [ Front Bumper Impact Absorber ] Front Bumper Impact Absorber.

7 Upper threaded bushing

• Secured against falling out with securing pin.

• No replacement part.

8 Upper adjusting screw

• Install completely before assembling bumper crossmember.

• Right-hand thread

• No replacement part.

9 Cover

• Removing and installing => [ Front Bumper Assembly Overview[1][2]Front Bumper Assembly Overview, From MY 2006 ] .

10 Nut

• Belongs to crossmember delivery casing.

11 Upper carrier bushing

• Plastic part pressed into adjusting screw.

• No replacement part.

12 Cross member