Bumper Crossmember to Impact Absorber Mount

Bumper Crossmember To Impact Absorber Mount

NOTE:
- Impact absorber is self-adjusting, meaning it can compensate bearing tolerances in height between crossmember and Impact absorber when installing the bolt.
- This holds and secures the crossmember automatically in the previously adjusted position when installing the bolt - 1 -.







1 - Screw
- 23 Nm

2 - Lower carrier bushing
- Plastic part pressed into adjusting screw.
- No replacement part.

3 - Lower adjusting screw
- Before assembling bumper crossmember, install completely but do not tighten.
- Left-hand thread
- No replacement part.

4 - Lower threaded bushing
- Secured against falling out with securing pin.
- No replacement part.

5 - Securing pin
- No replacement part.

6 - Impact absorber
- Removing and installing

7 - Upper threaded bushing
- Secured against falling out with securing pin.
- No replacement part.

8 - Upper adjusting screw
- Install completely before assembling bumper crossmember.
- Right-hand thread
- No replacement part.

9 - Cover
- Removing and installing

10 - Nut
- Belongs to crossmember delivery casing.

11 - Upper carrier bushing
- Plastic part pressed into adjusting screw.
- No replacement part.

12 - Cross member