Steering Lock Housing Adapter Wiring Harness

Lock Cylinder and Ignition Switch with Steering Lock

• The immobilizer induction coil is attached to the lock cylinder and cannot be replaced separately.

• If induction coil is faulty, lock cylinder must be replaced.

• When replacing the lock cylinder, follow the instructions regarding the immobilizer induction coil

Steering Lock Housing Adapter Wiring Harness

Removing





- Remove Steering Column Electronic Systems Control Module (J527) => [ Steering Column Electronic Systems Control Module ].

- Disconnect electrical connector - 3 - at ignition switch.

- Release retaining clips in - direction of arrow - and remove ignition key removal lock safety switch electrical connector - 2 -.

- Remove steering lock housing adapter wiring harness - 1 -.

Installing

Install in reverse order of removal, noting the following:

- Install Steering Column Electronic Systems Control Module (J527) => [ Steering Column Electronic Systems Control Module ].