Steering Lock Housing

Lock Cylinder and Ignition Switch with Steering Lock

• The immobilizer induction coil is attached to the lock cylinder and cannot be replaced separately.

• If induction coil is faulty, lock cylinder must be replaced.

• When replacing the lock cylinder, follow the instructions regarding the immobilizer induction coil

Steering Lock Housing

Special tools, testers and auxiliary items required

• Angled hand drill

• dia. 8.5 mm drill

Removing

- Extend the steering wheel fully and lower steering column.

- Remove airbag unit and steering wheel.

CAUTION.
Risk of damaging coil connector.

• Coil connector with slip ring is not to be turned following removal.

• Secure the coil connector and slip ring in the installation position with adhesive tape.

- Remove the steering column switch module trim.

- Drill out shear bolts - arrows - with an angled hand drill and dia. 8.5 mm bit.





- Pull the connector lock - arrows 1 -.





- Releases the connectors - arrows 2 - and disconnect them.

• The steering column with switch module removed is shown in the illustration.

- Disconnect induction coil wire on steering column switch.

- Remove steering column switch module from steering column.

- Remove Steering Column Electronic Systems Control Module (J527) => [ Steering Column Electronic Systems Control Module ].

- Release retaining clips - arrows - and remove steering lock housing - 2 - from mount - 1 -.





- Disconnect electrical connector on ignition switch.

In order to remove the steering lock housing, the starter switch and lock cylinder, and if equipped, the ignition key removal lock safety switch electrical connector, must be removed.

• Remove ignition switch => [ Ignition Switch ].

• Remove lock cylinder => [ Lock Cylinder ].

• Remove ignition key removal lock safety switch => [ Ignition Switch Key Lock Solenoid ].

Installing





Install in reverse order of removal, noting the following:

- Tighten bolts - arrows - until heads shear off.

- Install the steering column switch module trim .

- Install the airbag unit and steering wheel.