Plenum Chamber Coupling Station

Plenum Chamber Coupling Station

Observe notes on contact corrosion.







Removing
- Remove the wiper motor: vehicles through 05.2008, vehicles from 06.2008.
- Remove nuts - arrows -.
- Remove the cover - 1 - from the plenum chamber coupling station.







- Push the clamping strip - 2 - for the connectors in - direction of arrow -.
- Disconnect electrical connectors - 1 - and - 3 -.







- Release the retaining spring - 1 - and remove the terminal strip - 2 - from the base mount - arrow -.
- Unclip the corresponding connector base.

NOTE: Check the exact assignment for connector station E-Box plenum chamber in the current wiring diagram.

Installing
Install in reverse order of removal, noting the following:
- Install the wiper motor: vehicles through 05.2008 , vehicles from 06.2008 .
- Adjust wiper arms.

Tightening Specifications

Component Nm
Plenum chamber coupling station to body 3 Nm