Selector Shaft Oil Seal, Replacing (With Transmission Removed) (Transmission Remains Assembled)

Selector shaft oil seal, replacing (with transmission removed) (transmission remains assembled), 02X, 6-Speed Four-Wheel Drive M/T

Note:
^ Removal is also possible with transmission installed in vehicle.

Special tools, testers and auxiliary items required





^ Tube VW423





^ Extractor lever T20143/1
^ Assembly sleeve 01E 311 120
^ Sealing grease G 052 128 A1

Removing
With selector shaft installed





- Carefully pry out oil seal, making sure shaft is not damaged.





With selector shaft removed
- Carefully pry out oil seal using a screwdriver or oil seal extractor lever VW 681.

Installing





- Avoid damaging oil seal - C - by only installing oil seal and selector shaft using assembly sleeve assembly sleeve 01E311120 - A -.
- Pack space between sealing lip and dust lip half-full with sealing grease G052128A1.
- Lightly oil outer circumference of seal.





- Drive oil seal - arrow - into housing as far as it will go.