Right Connector Station, Removing and Installing

Right Connector Station, Removing And Installing

Removing







- Location: Right connector station - arrow - is located in right footwell beneath A-pillar trim.

CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.

- Remove A-pillar trim.
- Press retaining clip and detach connector point from A-pillar - arrow - .
- Unclip fuse panel at connector point.
- Remove relays or control modules and then unclip appropriate relay carrier.







NOTE: Refer to the applicable wiring diagram for exact identification of connections on connector station Wiring Diagrams .

Installing

Install in reverse order of removal, noting the following:
- Install A-pillar trim.