Clutch Pedal Switch F36, Removing and Installing

Clutch pedal switch F36, removing and installing, 02X, 6-Speed Four-Wheel Drive M/T

Note:
^ Clutch pedal switch may only be installed once so as to ensure a secure fit.

Removing
- Remove storage compartment on drivers side.





- Disconnect electrical connector - 1 - on clutch pedal switch.
^ The clutch pedal - 3 - is in the normal position (i.e. not pressed down). The operating rod arrow - of clutch pedal switch should then rest against clutch pedal.
- Release clutch pedal switch - 2 - by turning 45° counter-clockwise and remove from guide.

Installing





Installation is in reverse order of removal. Note the following:
- Pull out operating rod - arrow - all the way before installing clutch pedal switch.





^ The clutch pedal should be in the normal position (i.e. not pressed down).
- Guide clutch pedal switch through mounting hole, press against clutch pedal and attach by turning 45° clockwise.
- Connect connector for clutch pedal switch.
- Install storage compartment on drivers side.