Rear Fender Lamp/Bulb Carrier, Avant

Rear Fender Lamp/Bulb Carrier, Avant

Removing

- Turn light switch to position "0".

CAUTION!
• Switch off all electrical consumers.

• Switch ignition off and remove ignition key.

- Unclip plug - 1 - from luggage compartment trim - arrow - using a screwdriver.





- Remove screw - 2 -.





- Swivel rear lamp - 1 - outwards - arrow -, and at the same time disengage retaining pins from body.

- Disconnect electrical connection at bulb carrier.

- Press apart retaining tabs - arrows - and remove bulb carrier - 1 - from rear lamp.





- Turn bulbs to remove them from their holders.

Installing

Install in reverse order of removal, noting the following:

• Ensure seal between body and rear lamp housing seals completely.

- Fit rear lamp in position on body and press retaining pins into holes.

- Tighten screw.

Tightening Specifications